Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
| techlab:formi:bom [2020/10/07 11:17] – created ivo | techlab:formi:bom [2020/10/16 14:24] (current) – ivo | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ====== BOM ====== | ||
| + | Bill of Materials (Materialliste) | ||
| + | * PCB (Leiterplatine) | ||
| + | * RFM95 (LoRa-Chip) | ||
| + | * Temperatur- und Feuchtigkeitssensor | ||
| + | * Pin-Header **m**, 4 pins! | ||
| + | * 4-fach Dupont-Kable m/f | ||
| + | * CO2-Sensor | ||
| + | * Pin-Header m und f, 4 und 5 pins. | ||
| + | * Antenne | ||
| + | * Antennen-Anschluss | ||
| + | * WS2812b rgb-LED | ||
| + | * 3x Silikon-Dupont-Kabel f | ||
| + | * Pin-Header m, 3 pins | ||
| + | * Kondensatoren, | ||
| + | * ESP32 | ||
| + | * Pin-Header f | ||
| + | * QR-Code | ||
| + | * Lautsprecher | ||
| + | * Dupont-Kabel f, Schrumpf-Schläuche | ||
| + | * Pin-Header m, 2 pins | ||
| + | * Schrittmotor | ||
| + | * XH2.54 Pin Header Connector (weisser Stecker) | ||
| + | * Gehäuse (Holz) | ||
| + | * Limit-Switch | ||
| + | * 2x Dupont-Kabel f | ||
| + | * Pin-Header m, 2 pins | ||
| + | * Acryl-Glas Zeiger | ||
| + | * 1x Unterlagsscheibe aus Acrylglas (mit Zeiger) | ||
| + | * Schrauben und Muttern: | ||
| + | * Schrauben M3 | ||
| + | * 6mm 2x (für Motor) | ||
| + | * 8mm 6x (2x für Temp-Sensor, | ||
| + | * 10mm 1x (für Zeiger) | ||
| + | * 12mm 4x (2x für Ständer, 2x für Lautsprecher) | ||
| + | * Muttern M3: 9 Stück | ||